Inspection processes that form part of mast structural inspection include:
corrosion, mechanical integrity, welded joints, missing or loose fixings, disconnection of cables and connectors, bird nest contamination.

Radio frequency inspection processes include:
RF polar measurements, interference surveys, and antenna tilt and alignment analysis

About our drones:
Specially designed High Definition (HD) inspection cameras, InfraRed (IR) andRadio Frequency (RF) sensors are mounted on our custom build drone. It can be flown safely within less than 10 meters of the any point of interest and in wind speeds of 45 km/hr. Using a laser range finding system, the known positional accuracy of our drone and sensor array is < +/- 5 cm. The maximum altitude for normal operation is 1'500 m Mean Sea Level (MSL) and in extreme conditions 3'500 m MSL.

Flight paths can be directly (dialog) programmed or pre-programmed using satellite maps and GPS navigation software. During the inspection process all images and data are transmitted to a main ground station for direct visualisation and recorded for post processing and spectrum analysis. Our drones are piloted by our trained proffesionals and the sensors arrays and camera systems can be remotely controlled by inspectors, engineers and technicians who are qualified for telephone mast inspection, or managed by the telecom network technical experts.

Drones can also be connected to an LTE network in a specific area to capture data for analysis through remote company servers to allow for networking changes and fixes in real time if problems occur.

"The sky's the Limit"